Charcolite Platinum Powder Lightener 500gr / 17.6 oz

MIXING

* Mix in a 1:2 ratio— for every 1 oz of Charcolite Powder, add 2 oz of Difiaba Cream Developer (5–40 volume).
* Blend thoroughly until the mixture achieves a uniform grey consistency.

IMPORTANT:
Charcolite contains BondPlex, an integrated bond builder. Do not add any external bond builders, as this may reduce the lightening power.

APPLICATION

* Apply only to dry hair
* Use the mixture immediately after preparation for best performance.
* Fully saturate the hair surface to ensure an even and optimal lightening result.

PROCESSING

* Processing time will vary based on the desired level of lift.
* The level of lift increases with time: up to 45 minutes per application.
* If additional lift is needed after 30 minutes, prepare a fresh mixture and apply directly (without rinsing) for an additional 15–20 minutes (45–60 minutes total).
* To visually check the lift, wipe a small strand with a dry towel.

IMPORTANT:

* Charcolite Platinum Powder performs best at body temperature (95–105°F / 36–40°C).
* While additional heat is not always required, for applications far from the scalp, use a mild heat source to maintain hair temperature within this range.
* Do not exceed 105°F (40°C)
* For freehand painting and balayage, use a higher volume developer and ensure the ambient temperature is no lower than 72°F (22°C) for consistent lift.

RINSING

Once processing is complete:

1. Rinse thoroughly until water runs clear.
2. Wash with Charcolite Cool Toning Shampoo.
3. Condition with Charcolite Cool Toning Conditioner to neutralize unwanted warmth and enhance cool tones.

No. Charcolite Lightening Powder is designed for off-scalp techniques only.

For on-scalp applications, use Charcolite Lightening Paste, which is formulated for both on- and off-scalp use.

If you lift to level 10, Charcolite's Graphite Pigments usually deliver a cool platinum blonde with no separate toning step. At levels 8–9 the result is more neutral: to reach a specific cool or customized shade, finish with Charcolite Gloss Toner (zero-lift, cream-based, made for lightened hair).

No. Charcolite already contains BondPlex, a built-in bond builder that strengthens and protects the hair during lightening. Adding external bond builders may reduce lift and alter the formula’s performance.

The recommended developer varies based on hair texture to ensure consistent lift and minimal damage.

• Fine hair: Use 20 Vol (6%) developer and process for 45–60 minutes total.
  
• Medium hair: Use 30 Vol (9%) developer and process for 45–60 minutes total.
  
• Coarse hair: Use 40 Vol (12%) developer and process for 45–60 minutes total.
  

Tip: Always monitor the lift visually during processing. If additional lift is needed after 30 minutes, prepare a fresh mixture and reapply without rinsing for up to 20 more minutes.